At a choice of a place for garage building first of all pay attention to an arrangement of access roads. Entrances and departures from garages should provide the good outlook.

Entrances and departures it is the most expedient to have in relation to roads with a one-way traffic.

Garage it is desirable to arrange as it is possible closer to entrance on a lot. It can be approached closely to a site fencing so that gate was flush with fencing and left directly on street.
Chosen for building of garage the platform should be equal. It is desirable to execute also a certain complex of works on drainage for prevention of bogging or flooding of platforms.

For site drainage it is possible to dig drainage ditches in width about 50 cm and depth not less than 1 m. Ditches are filled with densely stamped building dust or stones to level of a vegetative layer and covered with earth.

Strongly humidified sites can be drained by means of a trench depth to 1 m with the bottom, which has been laid out by crushed clay, generated in the form of a tray. On clay put asbestos-cement pipes in diameter from 10 to 15 cm. On the top part of pipes do kerfs on one third of diameter of a pipe after every 10—15 cm.

After that trenches fill in at first with rubble, then a ground. Dig out at first one trench with a bias that water, which gathers in a pipe laid in trench, could flow out. Then to this channel bring a number lateral in which water from a site also gathers. At a lining of pipes it is necessary to observe size of their bias, which should not exceed 1 cm on 2 m of length of a pipe.

Near to a building site prepare places on which there will be large-sized building materials. Arrange them so that they did not prevent to the further moving and a building.

In advance think over, where you will store small-sized materials, tools and working clothes. For this purpose is better to use a shed in which it is expedient to equip a joiner’s shop.

Now it is possible to start location of the plan of garage. For this purpose on a place where there will be a garage, completely remove a vegetative ground. Then transfer on a site intended under building, the garage plan in the natural sizes, using for this purpose the goniometric tool, tape measure, a cord and wooden stakes.

Location begins with definition on district of extreme angular points of a construction dimension. The recommended sizes 3,850 X 5,500 m. By means of pulled on profile a cord carry out location of axes of the bases under bearing walls.

Profile is usually arranged from the stakes driven in the earth in the thickness of 12-14 cm to which at height 75 — 100 cm from earth level are beaten boards on an edge. The thickness of a board 2,5 and width is 16-18 cm. At installation of profile the topside of a board verify on level that it was strictly horizontal.

You should establish profile on distance not less than 1,5 m from external sides of future walls that digging of tranches under the base has not led to its collapse. Profile is possible to arrange continuous, on all perimeter of walls, or faltering — at four corners of garage.

If you need portable car garages – this site will help. Lots of samples of car garage products and direct access to the car garage sellers. All contact info on the site.

P.S. And don’t let laziness to stop you from finding the best deal about car garages. Don’t forget that we live in the world where info quickly enhances the quality of our life.

Due to this if you are properly armed with the knowledge in your sphere of interest you can rest assured that you will in any case find the solution to any bad situation. So, please make sure to visit this site on a regular basis or – best of all – sign up to its RSS. In such an easy way you will have a direct shortcut to the freshest info updates here. Blogging can be helpful, you just need to know how to use them.